P4-40-5248 Floor Height Load Leveler

• Oversized Platform	• Platform with Beveled Edges	• Electro-Mechanical Toe Guard
• Pit Mounted Units	• Lifting Eyes	• Ball Transfer Tops
• V Grooved Wheels	• Fork Pockets	• Turntables
• Detent Stops	• Conveyor Top	• Conveyor Sides
• Optional Top Material	• Super Cycle	• Series Specific Options

---

Oversized Platform
platforms can be increased in width and length up to additional 24". Side and end load capacities are derated 2 percent per inch of increase and oversized models must be lagged to the floor.
Platform with Beveled Edges
welded at 30 degrees angles increases / the standard platform by 4" on all sides.
Electro-Mechanical Toe Guard
mounted to the under side of the platform / adds 4" on all sides.
Pit Mounted Units
For ground level applications require either a Platform with Beveled Edges or Electro-Mechanical Toe Guards.Lifting Eyes required for installation and External Motor recommended
Lifting Eyes
provided for installation and transporting of unit with a sling or lifting chain.
Ball Transfer Tops
For multi directional movement of work loads / available for all load weights. Adds 2 3/4" to overall lowered height.
V Grooved Wheels
5" steel wheels for Transportable Units only / sold per pair.
Fork Pockets
Used for moving scissor lifts between work stations.
Turntables
Constructed of 1/2" steel plate andmounted on a 24" x 24" base plate equipped with a pivot pincaptured bearing and four 1 3/4 cam followers. Base hasmounting holes for lagging unit to table top / floor stand
Detent Stops
Spring activated stops for a Turntable / standard stops positioned at 90 degrees increments.
Conveyor Top
Mounted to the lift table platformthese 1.9” diameter rollers on 3” center have a1000 lb capacity per linear foot. Adds 4" to overall height.
Conveyor Sides
Used to retain product onconveyor tops / recommend on all Transportable Units.
Optional Top Material
For special handling of loads / v tops / aluminum material / stainless steel / diamond plate / etc.
Super Cycle (XL and Wide Base units only.)
For high cycle applications consult Material Flow for pricing. Components in base frames have been designed for high volume repetitive lifting applications.
Multiple Series Specific Options
Please Call for more information

---

• Upgrade to 1.5 HP Three Phase w/ 1 GMP Pump	• External Remote Power Units	• 1 HP Single
• Upgrade to 1.5 HP Three Phase w/ 2 GMP Pump	• Upgrade to External 5 HP Three Phase	• Air Motors
• 3 HP and 5 HP motor/pump units available	• Fire Resistant Hydraulic Fluid	• Low Temp Oil

Available Electrical Options

• NEMA-4 Hand Control w/ 8 in. Cord	• NEMA-12 Hand Control	• NEMA-4 Hand Control w/ 20 in. Cord
• Wall Mounted Control	• Limit Switch	• Pedestal Mounted Controls
• Floor Stand	• Motion Stabilizers	• Increased Vertical Travel